TPS2343DDPR

595-TPS2343DDPR
TPS2343DDPR

Fabricante:

Descripción:
Controladores de voltaje intercambiables en caliente Dual Slot PCI-X 2.0 Hot-Plug Pwr Cntrlr

Ciclo de vida:
Obsoleto
Modelo ECAD:
Descargue Library Loader gratis para convertir este archivo para su herramienta ECAD. Conozca más sobre el modelo ECAD.
Mouser actualmente no vende este producto en su región.

Disponibilidad

Existencias:

Atributo del producto Valor de atributo Seleccionar atributo
Texas Instruments
Categoría de producto: Controladores de voltaje intercambiables en caliente
Restricciones de envío:
 Mouser actualmente no vende este producto en su región.
RoHS:  
PCI Power Management
1.25 A
13.2 V
10.8 V
2 Channel
3 mA
- 40 C
+ 85 C
SMD/SMT
HTSSOP-80
Reel
Cut Tape
MouseReel
Yes
Marca: Texas Instruments
Sensibles a la humedad: Yes
Tipo de producto: Hot Swap Voltage Controllers
Serie: TPS2343
Cantidad de empaque de fábrica: 2000
Subcategoría: PMIC - Power Management ICs
Peso de la unidad: 262.400 mg
Productos encontrados:
Para mostrar productos similares, seleccione al menos una casilla de verificación
Seleccione al menos una de las casillas de verificación anteriores para mostrar productos similares en esta categoría.
Atributos seleccionados: 0

MXHTS:
85423999
CNHTS:
8542319000
USHTS:
8542390090
TARIC:
8542399000
ECCN:
EAR99

LM5060 High-Side Protection Controllers

Texas Instruments LM5060 High-Side Protection Controllers with Low Quiescent Current offers intelligent control of a high-side N-channel MOSFET during normal on/off transitions and fault conditions. The constant rise time of the output voltage results from the inrush current control. Both an Input UVLO (with hysteresis) and a programmable input OVP are provided, with an enable input offering a remote on or off control. The initial start-up VGS fault detection delay time, the transition VDS fault detection delay time, and the continuous over-current VDS fault detection delay time is programmed from a single capacitor. The MOSFET is latched off until either the enable input, or the UVLO input is toggled low and then high when a detected fault condition persists longer than the allowed fault delay time.